Rose electronics UC2-1x16U/E Instrukcja Obsługi Pobierz pdf (Strona 15)

INSTALLATION

ULTRACONSOLE INSTALLATION AND OPERATIONS MANUAL 9

Switch Installation – Single Unit

The basic installation of a single UltraConsole switch is an easy and straightforward procedure. Perform the below

steps for all computers that will be connected. It is recommended that all computers be powered off. When a

computer is connected and then booted, the UltraConsole will automatically determine the keyboard and mouse

types used for that computer and no pre-configuration of the CPU port is needed. It is recommended that the CPU

port be configured if the connected computer uses other than a PC2 keyboard and PS/2 mouse.

Figure 2. Single Unit configuration

The Unit in Figure 2 can be any UltraConsole model

If removing power from a computer is not practical, it is best to pre-configure the UltraConsole to define that CPU

port’s keyboard and mouse types. This procedure should only be done if the CPUs keyboard and mouse can be

disconnected and re-connected without affecting the interface.

The default keyboard type is PC mode 2, and the default mouse type is PS/2. If the computer being connected, with

power applied, uses a PC2 keyboard and PS/2 mouse, no pre-configuration is needed. If not, pre-configure the

keyboard and mouse types for that CPU port before connecting the computer (steps 4a-4e). Perform the following

installation steps for each computer that will be connected to the UltraConsole. Sequentially connect the computers

starting with computer #1. Do not use the numeric keypad to enter values, use only the numeric keys above the

keyboard.

Please refer to the safety section before installation

KVM Station

CPU

Cable

KVM

Cable

PC’s

(1 of 16)

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 61 62

Brak uwag

Rose electronics UC2-1x16U/E Instrukcja Obsługi Strona 15